Trapezoidal sheet metal
The Roof-PIN type A can be used on trapezoidal sheet metal. When planning an object, the roof pitch can be choosen completely free. The Roof-PIN type A is attached to the raised beading of the supporting shell with 4 self-tapping screws. The corresponding mounting plate is designed in such a way that there is always a complete support and can be screwed into the existing holes. The height of the Roof-PIN is delivered pre-assembled to the required insulation thickness.
product types
The Roof-PIN type A is attached to the raised beading of the supporting shell with 4 self-tapping screws. The seal is made with a roof membrane, which is clamped between the lower part with thermocouple and the upper part, which is fixed on the supporting shell. For this purpose, the roof membrane is only punctured minimally and the puncture point is also slightly elevated, which guarantees long-term impermeability.
more information
The Roof-PIN type A is attached to the raised beading of the supporting shell with 4 self-tapping screws. The seal is made with a two-layer bitumen sheeting and a stainless steel sheet, which is clamped between the lower part with thermocouple and the upper part, which is fixed on the supporting shell. The prefabricated stainless steel sheet is only minimally pierced and pressed on, and the piercing point is also slightly elevated, which guarantees long-term tightness. The bitumen layers are glued over the entire surface up to the Roof-PIN.
More information
