The Roof-PIN type S is attached to the wooden support shell with 4 wood screws. The seal is made with a two-layer bitumen sheeting and a stainless steel sheet, which is clamped between the lower part with thermocouple and the upper part, which is fixed on the supporting shell. The prefabricated stainless steel sheet is only minimally pierced and pressed on, and the piercing point is also marginally elevated, which guarantees long-term tightness. The bitumen layers are glued over the entire surface up to the Roof-PIN.
This is a single attachment point, where only the upper part has to be replaced when it is used. The roof skin does not have to be opened to replace the bent anchorage point.

The Roof-PIN type S is attached to the wooden support shell with 4 wood screws. The seal is made with a two-layer bitumen sheeting and a stainless steel sheet, which is clamped between the lower part with thermocouple and the upper part, which is fixed on the supporting shell. The prefabricated stainless steel sheet is only minimally pierced and pressed on, and the piercing point is also marginally elevated, which guarantees long-term tightness. The bitumen layers are glued over the entire surface up to the Roof-PIN.
This is an attachment point for "cable guides" where only the upper parts have to be replaced when used. The roof skin does not have to be opened to replace the bent attachment points.

The Roof-PIN type S is attached to the wooden support shell with 4 wood screws. The seal is made with a roof membrane, which is clamped between the lower part with thermocouple fixed on the supporting shell and the upper part. For this purpose, the roof membrane is only punctured minimally and the puncture point is also slightly elevated, which guarantees long-term impermeability.
This is a single attachment point, where only the upper part has to be replaced when it is used. The roof skin does not have to be opened to replace the bent anchorage point.

The Roof-PIN type S is attached to the wooden support shell with 4 wood screws. The seal is made with a roof membrane, which is clamped between the lower part with thermocouple fixed on the supporting shell and the upper part. For this purpose, the roof membrane is only punctured minimally and the puncture point is also slightly elevated, which guarantees long-term impermeability.
This is an attachment point for "cable guides" where only the upper parts have to be replaced when used. The roof skin does not have to be opened to replace the bent attachment points.